Combination Chuck/Spindle for Case Turning Lathe$85.00
This product includes our new Threaded Chuck Spindle and the Jacobs Keyless Chuck (30-002-030 and 30-002-040) assembled and ready to go on your Case Neck Turning Lathe. You can chuck a case neck brush, primer pocket uniformer, flash hole reamer or any other accessory you want to power with the Case Lathe. Spindle fits any 5/16” shaft and includes two set screws. See text for Spindle and Chuck in this Category, there is a small discount for this combination over the Spindle and Chuck ordered separately, and we “Locktite” the chuck on the spindle (medium strength). Note: When using the Chuck/Spindle on the Benchrite Case Lathe use only the front set screw – the second screw is not needed and you won’t have to remove the motor assembly from the base to get at the rear set screw.